views-and-annotations.md
GitHubChoose the view and its annotation grammar
Align orthographic views
Use a common scale and preserve corresponding widths, heights and hole positions between views.
Follow the supplied projection convention. Without one, select and label a convention explicitly. Third-angle places the top view above the front and the right-side view to its right.
First-angle places those views below and to the left. Never combine the two arrangements on one sheet.
Use hidden edges only where they explain features absent from the visible outlines. Draw centerlines through holes and axes rather than adding a background grid.
Cut material, not empty space
Locate the cutting plane on a parent view, label both ends and show the viewing direction. Give the resulting section the same designation, such as SECTION A-A.
Hatch the solid regions intersected by the plane. Leave holes, passages and open cavities clear. Vary hatch direction or spacing between adjacent components.
For an illustrative section, start with 45° hatching at 2–3 mm spacing on paper. Enlarge narrow regions or adjust spacing before they become solid black.
For formal drafting, check the chosen standard's exceptions for ribs, shafts and fasteners. A visually plausible cutaway does not establish standards compliance.
Attach each balloon to one item
Use sequential item IDs from the inventory, without renumbering them when the layout changes. A parts list has ITEM, DESCRIPTION and QTY columns.
Quantities describe the complete depicted assembly. One balloon may identify repeated identical fasteners; the parts list gives their total count.
Place balloons in loose perimeter lanes, ordered to reduce leader crossings. Start with 7 mm diameter circles and center their numbers optically.
Route a leader from its feature to one elbow, then to the balloon edge. Use a small filled dot on a surface or an arrowhead at an edge.
Keep at least 2 mm between a leader and unrelated lettering. Prefer moving a balloon over adding another elbow.
Use stable feature anchors, such as cover.fastener[0].center, rather than guessing a nearby screen coordinate. Reproject anchors whenever the view changes.
Dimension only what is established
Dimension model-space features in the view that shows their true shape. An exploded gap is a layout choice, never a product dimension.
Derive dimension labels from the same parameters as the geometry. Distinguish diameter Ø from radius R, and give units once for the sheet unless values use mixed units.
Prefer an orthographic view for dimensions, with extension lines outside the part. Start the first dimension 10 mm from the silhouette and successive dimensions 7 mm farther out.
Leave a 1 mm gap before each extension line and extend it 2 mm past the dimension line. Use filled arrowheads about 2.5 mm long.
These spacing values are an illustrative sheet recipe. A supplied drafting standard or established drawing template takes precedence.
Keep numbers readable from the sheet's chosen reading direction. Put radius leaders on the actual arc.
In circular views, place diameter lines through the circle's center. In axial views or sections, span the corresponding outside or inside surfaces and retain the Ø prefix.
Use NTS for fitted illustrations. Claim a numeric scale only when model units, projection and physical page output were all checked.